With their twin bright red bands around the top and bottom, these should not be confused with the many inferior types of foam air filters available on the market!!
These red bands are the visible part of two fibre-reinforced nylon injection mouldings which form the structure on which ITG's unique TriFoam filter system is bonded.
The two outer layers of foam provide optimum filtration and load up capacity while the inner layer is made of special self extinguishing filter foam. Together, they give the best combination for air flow, engine protection and safety. The Megaflow filter range are designed to fit on to ITG's own baseplates, these are made from steel which are bright red in a powder coated protection.
Fitting Advice:
Selection of the filter element depends on the amount of room available.
ITG recommend fitting the tallest element possible, though a gap of 0.5 inch (13mm) average must be left over the top of the filter for air to circulate.
If using ram pipes, there must be an absolute minmum gap pf 0.75 inch (19mm) or preferably 1.25inch (32mm) between the end of the pipe and the underside of the filter.
ITG Megaflow filters are designed to fit onto their red backplates, and are secured with one or more quarter turn fastners. The Megaflow filters are normally supplied unoiled or dry, and need to be oiled prior to use. Oil can be bought from the ITG accessories section.
Please note that all filters are available in either domed or flat top options, please select which option is required.
There are many other options to the list attached so please do not hesitate to call us for any further information you may require.
Filters at a glance:
JC20: Single carburetter filter - 192mm Length 148mm Width
JC30: Single carburetter filter - 298mm Length 149mm Width
JC40: Small twin carburetter filter - 379mm Length 142mm Width
JC50: Big twin carburetter filter - 436mm Length 148mm Width
JC100: Multi carburetter filter - 608mm Length 142mm Width |
